Metal Down Lead Tension Clamp for ADSS/OPGW Cables – Tower & Pole Mount

The down-lead clamp is used to fix the cable to splice pole/tower and termainal pole/tower in the down-lead to the closure.In gernal,each 1.5 meters is supplied with a set

It is used to fix cable to the tension tower.In gernal,Each tower is supplied with 2 sets

For corrosion resistanct u-shaped clamp body of galvanized steel,clamp block is made up of hot galvanized steel

Down Lead Clamp is designed to lead down cables on splicing and terminal pole/tower and to fix the arch section on the middle reinforcing pole/tower. Normally, a unit of Down Lead Clamp is needed 1.5meters, and it is also used in other fixing area.
Used to place surplus optical cables for connecting ADSS/OPGW optical cable overhead lines and connect them to the optical cable. The head box is used in conjunction with each joint box, usually equipped with a spare cable rack.

Downlead wire clamp assembly uses: under the guidance of fixture is mainly used for fixing the installation of ADSS and OPGW on the tower of the cable wire. Such as the cable bar joint (tower), cable from the clip to hardware leads to connection protection box is arranged at the fixed effect; cable from the tower lead to underground pipes, cable trench, buried, and lead to enter the engine room of the fixed. To avoid cable under the action of wind and tower or other objects of friction and damage of the cable, in order to protect the safety of the cable. We can provide the following models of the lead jig, respectively, are: the tower lead the jig and the pole type lead jig.

1）High mechanical strength  performance
2）Hot dip galvanized surface treatment against rust and corrosion
3)Wide scope for different diameter pole mount
4)Easy mount around pole 

1. For fiber optic cable connecting tower, tower cable lead terminal and the middle under the arched part of the tension cable tower fixed, each 1.5 meters with a set of general, other needs can also use a fixed place.

2. The down lead clamp is used in the immobility of OPGW/ADSS on pole/tower. It is suitable for the riveting of fiber when jumping or down lead. And it was commonly installed every 1.5 to 2 meter each set. This clamp bears the excellence of easy installation, wide adjustable range and suitable for different Dia.